Engenius eap1300 - flashing process

Has anyone been able to flash the EAP1300? It's listed as a supported device. I have tried flashing the firmware downloaded from Openwrt. So far no luck the device says its flashing but doesn't restart. If i then power cycle it later, after say 10 minutes, it comes back up with the stock firmware.

What am I missing?

Does the installation work when you follow these EAP1300 Installation Instructions?

Thank you for the help! Updating to the stock firmware 3.5.5 allowed me to flash openwrt from the web gui.

If your problem is solved, please consider marking this topic as [Solved]. See How to mark a topic as [Solved] for a short how-to.

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.