Wr902ac v3 8mb to 16mb storage

[imran1441]

SPI flash upgrade from 8MB to 16MB on Archer C6

Hey guys, I am upgrading my TP Link Archer C6 v2 (EU) flash from 8MB to 16MB. I have read other discussions on this and I have a few questions regarding what needs to be flashed on 16MB chip. These are the steps I am going to follow. Dump the 8MB flash to a file. Concatenate the file with itself to create a new 16MB(8+8) file, so that ART partition is at correct place. And then write it to the new 16MB flash. Solder the new flash and enjoy. Are these steps enough? I also want to move to US…

TP-Link WR941ND v5.0 4MB to 16MB flash upgrade

I have this router laying around and decided to make a flash upgrade for better use with OpenWRT. The original flash is an EON EN25Q32(A/B) 4096 kB SPI, replaced to a Winbond W25Q128.V 16384 kB, SPI. A Raspberry Pi with a SOIC/SOP8 test clip, basic soldering skills and flashrom are needed (https://github.com/stefanct/flashrom.git). [001] The first step is to desolder the original flash chip from the board and fit it into the test clip. I find it's much easier to deal with it already desolder…

Upgrade spi flash 8mb -> 16 mb

I'm thinking of replacing the spi flash of my tplink archer c20 v5 which is currently 8 MB with a 16 MB one, so I'm trying to create a suitable firmware and to do so I'm using the image-builder tool but I can't find the definitions to be changed relating to flash layout (8MSUmtk), can anyone who has already done it give me a hand?

I will try this my device but not work

Can tel me how to cut 8mb firmware, Bootloader And ART partition in Terminal Command ?