R6850 / 21.02.0 Switch Section Missing

[manjotsc]

Hi,

I have installed OpenWRT on R6850, but I am missing the switch section for VLANs setup.

OpenWrt 21.02.0 r16279-5cc0535800

[faser]

@manjotsc

OpenWrt 21.02.0 r16279-5cc0535800

DSA supported device?

Mini tutorial for DSA network config

Update from 2021-05-31: Option ifname was renamed to device This tutorial is valid for 21.02-rc2 (or newer) and recent snapshots Introduction DSA stands for Distributed Switch Architecture and is Linux kernel subsystem for network switches. It's an upstream replacement for OpenWrt's swconfig framework and many new routers use DSA drivers instead of swconfig drivers. In DSA each switch port is a separated Linux interface. It means ip / ifconfig command will show interfaces like lan1, lan2, w…

[manjotsc]

How can I fix it? I have upgraded to OpenWrt 21.02.1 r16325-88151b8303 same issue.

[frollic]

Fix what?
It works as designed, with DSA.

Read the link provided.

[manjotsc]

Sorry I am little confused, so the config can only done using Manual Config?

[anon89577378]

DSA enabled routers do not have the "Switch" tab.

Current thread...

Netgear r7800 VLAN question OpenWrt 21.02.1

switch tab = swconfig (no dsa) use the 'old guides' but when you need to use the drop down in 'interface'(new L3 adapter for each vlan) for devices... you now may have to hop over first to the 'devices' tab to set up that config-network-device element there...

[manjotsc]

Here's how my setup is, the openwrt is being use as access point, I have my main router as DHCP(pfSense) and I have VLAN13 I want to pass thru to Openwrt from LAN port. Any guide?