I followed this guideline
https://openwrt.org/toh/seagate/goflexhome
for installing OpenWrt on a GoFlex Home unit but unfortunately on reboot it didn't boot OpenWrt 
...
NAS>> reset
<------> -- NAS EXPLORER --
_ _ ____ _
| | | | | __ ) ___ ___ | |_.
| | | |___| _ \ / _ \ / _ \| __|.
| |_| |___| |_) | (_) | (_) | |_.
\___/ |____/ \___/ \___/ \__|.
** QSI BOARD: NAS-PLUG LE.
U-Boot 1.1.4 (Jun 10 2010 - 08:28:13) Marvell version: 3.4.27
QSI NAS version: 1.0.4
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CFB00
Soc: 88F6281 A1 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz.
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 128MB.
DRAM Total size 128MB 16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:256 MB
Flash: 0 kB
CPU : Marvell Feroceon (Rev 1)
Streaming disabled.
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME]
Hit any key to stop autoboot: 3 ^H^H^H 2 ^H^H^H 1 ^H^H^H 0.
NAND read: device 0 offset 0x100000, size 0x600000
Reading data from 0x100000 -- 0% complete.Reading data from 0x10f000 -- 1% complete.Reading data from 0x11e800 -- 2% complete.Reading data from 0x12e000 -- 3% complete.Read
6291456 bytes read: OK
## Booting image at 00800000 ...
Image Name: Linux-2.6.22.18
Created: 2010-06-17 5:37:59 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2095148 Bytes = 2 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... Bad Data CRC
NAS>> exit
Unknown command 'exit' - try 'help'
NAS>> ~
[EOT]
Any suggestions as to what happened or what to do?
Does this install require a particular U-Boot to be installed for it to work?
