Hi
just a few things I have noticed
none of the 2 buttons seem to be mapped to reset
I think this would help people reconnecting when there is a fault as seen in this thread
knowing that pausing the button on the back would factory default the settings would be good
also as the device is left in developer mode this won't allow you to leave a storage device
plugged in while boot due to it trying to boot off it
I guess you could put openwrt on that device but just makes it more complicated
I did test leaving developer mode it with an early version
but just left the led's in the red/orange brick mode
is there a way for us to get out of debug mode to usb will work etc
also trying to boot back off the USB to gain control due to not being able to factory default
seems to use the bad partition in the unit rather then the one from the USB
so the only way to recover is to use the onhub recover usb to over right the flash
so the openwrt USB will boot correctly