Hi, I am trying to make a bridge, following this tutorial. (https://zerotier.atlassian.net/wiki/spaces/SD/pages/7438339/Layer+2+Bridging+with+LEDE+OpenWRT)
Reading I have noticed that there are differences between the explanation and the image and I do not know which would be the correct way.
Assuming that the LAN is 10.99.4.0/23 and the Zerotier is 10.99.5.0/23 in managed route, which one should I put? because when you type it it says 10.99.5.0/23 and in the image 10.99.4.0/23
I'm not sure what the author of that guide is doing. A layer 2 bridge wouldn't need assigned IP addresses at all. Just put zt0 into the LAN bridge and done, it uses the IP of your LAN and your DHCP server (not zerotier) will provide an address to the road warrior at the other end. I assume you'd need to check allow Ethernet bridging on both peers.
I've never actually done that though, I use Zerotier at layer 3.
1 Like