I recently upgraded my WRT3200ACM with DavidC502's build. Previously I was running one of his, which was LEDE. Now the gui takes a long time to load, sometimes it does not load at all, othertimes it errors out and says "XHR request timed out". Any idea how to fix it? I have done a factory reset by doing a 30-30-30 (not sure if you guys do this anymore). More info:
Holding down the reset button for, as I recall, 5 seconds was all that was needed under OpenWrt. The power-cycle regimen comes from the days of the WRT54g and, as I recall, its use of NVRAM for storage. It "does nothing" for current NOR- and NAND-based routers.
Dear Lodi,
Hello and I hope that you are well. I have been quite happy running DavidC502's Build's on the WRT3200ACM and WRT32X for years now and I am an active member of his Community Forum found here: : Davidc502- wrt1200ac wrt1900acx wrt3200acm wrt32x builds and his website : https://dc502wrt.org/ -
Dave's Community Thread in addition is frequented by OpenWRT experts and mavens plus there is great advice and support on the Community Thread and you can even request new packages and features.
As far as resetting the WRT3200ACM or any of the Routers which Dave supports listed here:
Current images built and distributed.
WRT1200ac Version 1 and 2
WRT1900ac Version 1 and 2
WRT1900acs Version 1 and 2
WRT3200acm Version 1
WRT32X Version 1
See this page to reset your router to default settings and clear ram : https://www.routerdefaults.org/linksys/wrt3200acm - doing a 30-30--30 reset potentially has you running the risk of bricking your router. Follow these steps in order:
Press the reset ( hold it down ) for 20 seconds - watch the lights flash - wait for unit to reboot fully - next unplug the router - wait 30 seconds. Then plug the router in once again - let it boot up. Then you are done. Hope this helps.
I'm seeing this issue as well with a build from the current snapshot. The behavior isn't due to an issue with the Web UI; it appears to have something to do with the network stack. If you ssh into the router when it's experiencing the problem and attempt to do a netstat or an ifconfig, the session will just hang.
Looking at memory utilization shows a significantly higher-than-normal utilization:
root@orion:/usr/local/bin# free -m
total used free shared buff/cache available
Mem: 498 398 66 11 34 53
Swap: 62 0 62
root@orion:/usr/local/bin#
Hi Anonmeome, i am on ssh - the link from forum thread you sent, the make file ? How can i download the patch? is it by .bin or .img? its just redirecting me to a source code instead..
I have Winscp to transfer and command to sysupgrade.. please help.. thank you.