I have the following installed on a NETGEAR R6350 but I dont' see the word USB anywhere in the LuCi menu (specifically not in System menu where I think it should be) so I can't access usb:
kmod-usb-core - 5.15.162-1
kmod-usb-ledtrig-usbport - 5.15.162-1
kmod-usb-storage - 5.15.162-1
kmod-usb-xhci-hcd - 5.15.162-1
kmod-usb-xhci-mtk - 5.15.162-1
kmod-usb3 - 5.15.162-1
How to a modify the Luci menu so I can see my usb modules? On my GL.iNet GL-MT300N-V2 installation, I am able to see a menu with the word USB. Why the difference?
What are you trying to do? You see USB in Status/log as it gets connected. You need usb class driver, for storage it is usb-storage and uas , for webcam it is uvc
You need to be more detailed.
I don’t know which one of these that you don’t have it is, but one of these get system->’mount points’ and ‘mount points’ added as memory under Storage in Status->Overview in luci
usbutils
block-mount
f2fs-tools
Believe it is block-mount since that one gave the fstab config file if I remember right?
In Luci, I want to have a screen that shows me if I have an USB drive plugged in and if its is plugged in, what its name is. I would also like to be able to see what files it has on it. In the future, I would like to be able to use the USB drive to extend the memory of my router, if needed. I don't need the USB for storage or webcam. I'm just learning this firmware and trying to understand what it can do. I have a USB port and a drive plugged in. I have firmware, but it does not show me the drive, as I would expect. As i