although it was SOIC on this board, the fairly high pin count made the RAM swap a bit tricky,
and while I was super careful, I did manage to damage 3 pads,
so I had to solder in some hair strains, (blob of epoxy lower left on the RAM chip) .
as for the flash, I glued on a DIP socket, and soldered it to the pads.
I'm using an adapter with an SOIC8 package instead of the 16pin one
I have not had time to work much more on building the 16MB Flash image yet,
but it certainly makes for faster prototyping this way.
Rune