Info:
ASTORIA networks
Model Name of manufacture: ARV519rw22-a-lt VR9 1.2
HW Version: R02
FW Version: V00.96.114
Rating: 15V---1.66A
I try to do the following tutorial
I get stuck at point nine when trying point 9 ( Press the key ctrl+a, and then ctrl+s, next type in the file to transmit to router (typical uboot.bin that is located on linux machine) )
these are the volts of the wires of my UART cable:
red black -176
red white -294
red green 1430
I think this is not typical, I don't know if this has to do with the error that I show below.
This is the reason why I have not put the cables in the order indicated in this tutorial, but rather I have connected them as follows:
(black green white)
Later I download the compressed file where the u-boot.bin is located (u-boot_2013.10_dirty_arv7519rw22.zip)
I have tried all the files it comes with (u-boot-V11.bin, u-boot-V11_RAM.asc, u-boot-V12.bin, u-boot-V12_RAM.asc) although I suspect that the one I should install is u-boot-V11.bin or u-boot-V12.bin and not another.
here I leave the error when trying to install it:
well... now the error doesn't even appear anymore... now it just won't let me install
[VR9 Boot]:u
UPLOAD Flash
---------------------------------------
Area Address Length
---------------------------------------
[0] Boot 0xB0000000 512K
[1] Image 0 0xB1280000 6144K
[2] Image 1 0xB1880000 6144K
[3] Configuration 0xB1E80000 1024K
[4] Boot Parameters 0xB1F80000 256K
[5] Flash Image 0xB0000000 32768K
[6] Linux Image 0xB0080000 24576K
[7] Emergency Value 0xB1FC0000 2883584K
---------------------------------------
Enter area to UPLOAD: 0
ERROR: You can't upload this area.