TP-Link EAP650 v1 Support

Hardware Questions and Recommendations
1

Hello OpenWRT Forum,

I currently use a TP-Link EAP650 v1. (https://www.tp-link.com/en/business-networking/omada-sdn-access-point/eap650/v1/) (v2 is the same device but some other hardware revision I don't know off.)
I'm new to OpenWRT and I'm not sure if there is any firmware supporting this device. As the EAP650 lack the possibility to enter exceptions in Client Isolation Mode to prevent clients accessing each other but allowed to talk to a server (Which is on the same subnet, so I cannot apply firewall rules), I would like to use OpenWRT on this AP.

I tried to look for one her: https://firmware-selector.openwrt.org/
But could not find one, is there maybe one I could use?

Thank you in advance.

2

As far as I can see in FCCID, it’s IPQ5018, which is currently not supported. See also https://forum.openwrt.org/t/adding-openwrt-support-for-tp-link-re700x-ipq5018

3

I've got an EAP650 Outdoor, which is showing Version 1.6 on the motherboard. I can verify that it is an IPQ50xx device.

The IPQ50xx support is coming along nicely, and can be found here:

I have the serial boot log for this device available, but it is too large for a post here. I'll sort out getting a hardware page added to the wiki.