I deleted network.@switch_vlan [1] using uci delete because of the bridge mode configuration
Setting up network.@switch_vlan [1] using uci set to use router mode again does not work.
I think the arrangement is a problem.
Is there any other way?
If you don't have a backup of the settings prior to the change you applied, I suggest the following.
- Take a system backup
- Restore to defaults
- Check the configuration of the switch in the backup file:
/etc/config/network
- Apply the backup and manually edit the
/etc/config/network
to revert the original settings.
Packages that you installed post installation of the firmware will not be preserved, so take a backup of the installed list so that you can restore them later. There are guides in documentation about that.
1 Like