Support for Tenda BE12 Pro

[xiaobo]

Hardware Specification:

• SoC: MediaTek MT7987A (Quad-core ARM Cortex-A53 2.0 GHz)
• RAM: 512 MiB DDR4
• Flash: 128 MiB SPI-NAND
• WiFi: MediaTek MT7992E (WiFi 7)
  • 2.4GHz: b/g/n/ax/be (4x4 MIMO)
  • 5GHz: a/n/ac/ax/be (4x4 MIMO)
• Ethernet:
  • 3x 10/100/1000 Mbps LAN (Airoha AN8855AE Switch)
  • 1x 10/100/1000/2500 Mbps LAN (SoC internal PHY)
  • 1x 10/100/1000/2500 Mbps WAN (Airoha EN8811H PHY)
• Buttons: Reset, WPS
• LEDs: 2x (Blue: System/Run, Red: Alarm)
• UART: 115200 8n1 (VCC, RX, TX, GND)

Flash Layout:

• 0x000000 - 0x300000 : Bootloader
• 0x300000 - 0x380000 : u-boot-env
• 0x380000 - 0x780000 : Factory
• 0x780000 - 0xd80000 : kernel
• 0xd80000 - 0x6780000 : ubi (rootfs)
• 0x6780000 - 0x6b80000 : CFG
• 0x6b80000 - 0x6f80000 : MISC2

MAC Addresses (NVMEM):

• Base MAC located at Factory partition offset 0x4
• gmac2 (WAN) : Base - 2 (Label MAC)
• gmac0 (LAN) : Base - 1
• gmac1 (LAN) : Base - 3
• 2.4 GHz : Base
• 5 GHz : Base + 1

https://www.tenda.com.cn/product/BE12Pro

[brada4]

Looks like it has TTY solder points 1st picture top. Measure voltage there and try to get boot logs?

Can you get a link to a web page where you would download tenda firmware upgrades?

[xiaobo]

https://www.tenda.com.cn/prod/api/data/center/download/541288615886917/760742452559941

[brada4]

How about using proper model name

Device is fully supported
https://github.com/openwrt/openwrt/commit/7d79346581582fd609513640ccde74b0ca2537cc

You might consider your approach about adding ai inventions to device specs.

[andrewjlamarche]

I know this contributes literally nothing to the conversation, but WOW this might be the ugliest device I have ever seen!

[xiaobo]

@andrewjlamarche

WOW this might be the ugliest device I have ever seen!

Hahaha, don’t judge it by the "look" — it’s actually the outline of a mountain.(Five-Obelisk Complex)

[frollic]

Or a plastic pitch fork....

[brada4]

Batmans dentures

[castillofrancodamian]

Who makes the final "Yes" decision?