Hi, I'm thinking about buying the EAP225-Wall. The model has been mentioned in a thread about the EAP225-v3, but it looks like it would be a separate effort: [image] Anyone working on TP-Link EAP225? For Developers Looking at the GPL sources , the EAP225-Wall is supposedl…

Luck has it @Borromini sent me one two weeks ago, so the port is basically done. I need to clean up the commits, but if you want you can build it already. [image] svanheule/openwrt This repository is a mirror of https://git.openwrt.org/openwrt/openwrt.git It is for reference only and is …

How's your MT7621 chops eh? For a crack at that TP-Link EAP235-Wall once they start to sell that for real :upside_down_face:

Challenge accepted! Hopefully it doesn't need any difficult patches like the original EAP AC devices, then it shouldn't be too hard :stuck_out_tongue:

And by using KEY_LIGHTS_TOGGLE for the LED button, there is a trigger to use for toggling the LED. An example script can be found in the other topic linked below, and should probably go on the wiki if this device gets merged. [image] Toggle LED with push button For Developers …

They did at least release the EAP230-WALL recently, so are we lucky and will this one be on the list of supported devices as well? I might even help paying the hardware so you guys could get your hands on one.

The EAP-235 is popping up on Amazon for Europe as well now, so here's hoping they might actually be shipping somewhere in December.

Hey guys, I have one of EAP225-WALL v2, while official web page https://openwrt.org/toh/tp-link/eap225 tells me, Qualcomm Atheros QCA9561, Qualcomm Atheros QCA9886. The 2.4GHZ works fine, but it seems to have QCA9888 for 5GHZ, not QCA9886 like in the description: $ dmesg | grep -i qca [ 0.000…

Hello. I bougth EAP225-Wall V2 and I can't install OpenWRT after updating TP-Link firmware to v5.0.3 and following the instructions given on OpenWRT's EAP225 device page for EAP225-Wall. When trying to upload the "OpenWRT-factory.bin" image to the router, it says "bad file" (PS: I did not SSH'ed t…

[image] stman: PS: I did not SSH'ed to tun the cliclientd stopcs, I directly tried to upload the factory image from the web interface and it fails The instructions to install OpenWrt are already reduced to the smallest number of required steps. Not running cliclientd stopcs would result in ex…

OpenWrt Forum

Support for EAP225-Wall

For Developers

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled