Openwrt for Aruba AP-200 series

For Developers
1

Hi there.
I have these aruba AP-204

image
image1600×720 124 KB

I was searching and didnt find any firmware available for them. Maybe is possible to create one for them? I'm new to creating firmware and to these things but anything i'm willing to help in everything I can.
This is the console output on boot:



APBoot 1.5.3.5 (build 43311)
Built: 2014-04-19 at 02:39:36

Model: AP-20x
CPU:   BCM53011/15, revision A0
I2C:   ready
SKU:   2
OTP:   0xeca01028
Clock:
       CPU:  800 MHz
       DDR:  533 MHz
       AXI:  400 MHz
       APB:  200 MHz
       PER:  400 MHz
DRAM:  128 MB
POST1: memory passed
SF:    Detected MX25L25635E with page size  4 kB, total 32 MB
Flash: 32 MB
PCIe0: RC, link up
       dev fn venID devID class  rev    MBAR0    MBAR1    MBAR2    MBAR3
       00  00  14e4  4360 00002   03 08000004 00000000 00000000 00000000
PCIe1: RC, link up
       dev fn venID devID class  rev    MBAR0    MBAR1    MBAR2    MBAR3
       00  00  14e4  4360 00002   03 40000004 00000000 00000000 00000000
Power: DC
Net:   eth0
Radio: bcm43460#0, bcm43460#1

Hit <Enter> to stop autoboot:  0
apboot>

I just want to make this AP work like if it was a normal access point and work in it's own, no controller, no hub, just itself alone. Thanks for any advice

2

Broadcom radios are usually a dead end.

3

Any ideas of what other possibility there is to make this things work?

4

Not with OpenWRT, as frollic already said. Maybe with DD-WRT, ask there.