This is probably off-topic but I don't know where else i could find someone with inside knowledge of the KD22 firmware.
I've acquired a KD22 from Ebay and got the following problem: The setup wizard starts but does not get beyond step 1, setting language and timezone. After clicking 'Next Step' a progress bar appears and that's it.
I tried the HW reset button at startup which actually lets me choose language and timezone again but again I don't get beyond step 1. There must be something wrong with the setup wizard, The state is obviously not stored on one of the disks: the behavior is the same if I try to start without any disk.
I know this is not related to OpenWrt in the first place but I thought you might have a tip what else I could try to make the KD22 setup finish.
Thank you
Hans
Haha. Well Definitely off topic so "for developers" isn't the right place haha.
But anyway regarding openwrt support. It's an 88F6707
Internet archive does have the public datasheets which is nice. But marvell site doesn't have them listed anymore.
If serial's chatty, perhaps you'll be able to see where it's/what's stuck ?
1 Like