Logging in to MR18 running LEDE OpenWrt

Installing and Using OpenWrt
1

I have been using Meraki MR18 with LEDE as an access point. I originally set it up and need to log into it and review and make some changes for the SSIDs. How do I identify its IP address and log into it to make the changes?

Thanks,
ASenna04

2

depends how you set it up, but going by the MAC would be good start.

3

Thanks frollic.

So from the MAC address I can only see the router listed under the PPv6 address. It does not appear under the IPv4 address which I would normally type in the browser to get the logon screen for the MR18.

Any thoughts?

Thanks.

4

Any ideas please.

5

Wire up a serial connection

1 Like
6

Then use its IPv6 address. Some browsers won't do Link-Local; but a ULA is setup in OpenWrt by default too.

http://[<IPv6_address>]/

See: https://www.webhostingdiscussion.net/blog/how-to-access-ipv6-url-from-browser/

If that doesn't work:

Yes, this should always work, and was how OpenWrt was installed on it (I as I recall).

@hecatae - I just noticed...this was a 1+ year old thread.

1 Like