Install OpenWrt on TP-Link AP300

Hello everyone,
I have a TP-Link AP 300 on which I would like to install OpenWRT but I can't find any compatible version.

By connecting via serial I can only read what happens to boot below some information
do you have any advice on which version I can install?
Thank you

CFE version 6.37.14.93 (r469350) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Tue Mar 20 19:38:05 CST 2018 (tplink@tplink-pc)
Copyright (C) 2000-2008 Broadcom Corporation.

Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
DDR Clock: 533 MHz
Info: DDR frequency set from clkfreq=800,*533*
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.37.14.93 (r469350)
CPU type 0x0: 800MHz
Tot mem: 131072 KBytes

CFE mem:    0x00F00000 - 0x02F80C4C (34081868)
Data:       0x00F48930 - 0x00F48E04 (1236)
BSS:        0x00F48E10 - 0x00F7EC4C (220732)
Heap:       0x00F7EC4C - 0x02F7EC4C (33554432)
Stack:      0x02F7EC4C - 0x02F80C4C (8192)
Text:       0x00F00000 - 0x00F3F138 (258360)

Device eth0:  hwaddr 00-0A-EB-XX-XX-XX, ipaddr 192.168.0.254, mask 255.255.255.0
        gateway not set, nameserver not set
Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
... 4184064 bytes read
Entry at 0x00008000
Closing network.
Starting program at 0x00008000
console [ttyS0] enabled, bootconsole disabled
serial8250.0: ttyS1 at MMIO 0x18000400 (irq = 117) is a 16550
brd: module loaded
loop: module loaded
pflash: found no supported devices
bcmsflash: squash filesystem found at block 36
Creating 5 MTD partitions on "bcmsflash":
0x000000000000-0x000000040000 : "boot"
0x000000040000-0x000000240000 : "linux"
0x000000240000-0x000000ee0000 : "rootfs"
0x000000fe0000-0x000000ff0000 : "radio"
0x000000ff0000-0x000001000000 : "nvram"
nflash: found no supported devices
PPP generic driver version 2.4.2
NET: Registered protocol family 24

Then it's not supported, and if the rest is Broadcom, like the Ethernet chip and boot loader, it's not going to be, unless you fancy APs with crippled wifi.

thanks for your reply

Ola, já estou usando o openwrt no Ap300, quem está desenvolvendo é FabianoTss, e eu estou testando a compilação no hardware, é bem melhor que firmware da Intelbras, porém ainda tem algumas coisas a serem corrigidas

The preferred language in the OpenWrt forum is english.
When writing in your native language, please always provide an english translation.
This way other users all around the world can take part in the discussion and possibly benefit from the outcome, without having to use a translator.

Thanks! :slight_smile: