Hello! I download and flash from web interface the lede-17.01.4-oxnas-kd20-factory.tar.gz. After the flashing - the device don't work. I connect it with UART and it show NAND check sum is not ok. I have only acess to u-boot. Can you help me - how to restore the factory NAND or how to flash lede on the device again???
I must confirm that I got same issue as @vlado7 - I loaded openwrt-18.06.2-oxnas-ox820-shuttle-kd20-factory.tar.gz firmware and the device is bricked.
Currently I am trying to figure out how to revive this, use UART which I am unable to find so far. Any tips?
From your post it sounds like you will need to wire-up the UART and re-flash using U-Boot.
If you still need help with that, let me know.
I've also written a wiki page for the device, however, still lacking photos documenting the UART as well...
1 Like
This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.