How to use wle1216v5-23 on wpq864

Plug wle1216v5-23 into the wifi0 and wifi1 slots, system prints firmware crash and not work,but plugging into wifi2 slot ,wle1216v5-23 works well, why ?this is the fragment of my dts file

                        pcie0_pins: pcie0_pinmux {
                                mux {
                                        pins = "gpio3";
                                        function = "pcie1_rst";
                                        drive-strength = <2>;
                                        bias-disable;
                                };
                        };

                        pcie1_pins: pcie1_pinmux {
                                mux {
                                        pins = "gpio48";
                                        function = "pcie2_rst";
                                        drive-strength = <2>;
                                        bias-disable;
                                };
                        };

                        pcie2_pins: pcie2_pinmux {
                                mux {
                                        pins = "gpio16";
                                        function = "pcie3_rst";
                                        drive-strength = <2>;
                                        bias-disable;
                                        output-low;
                                };
                        };

the following is the log:

[  212.017103] ath10k 4.13 driver, optimized for CT firmware, probing pci device: 0x46.
[  212.018844] ath10k_pci 0000:01:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0
[  212.200370] ath10k_pci 0000:01:00.0: Direct firmware load for ath10k/fwcfg-pci-0000:01:00.0.txt failed with error -2
[  212.200430] ath10k_pci 0000:01:00.0: Falling back to user helper
[  212.252513] firmware ath10k!fwcfg-pci-0000:01:00.0.txt: firmware_loading_store: map pages failed
[  212.255296] ath10k_pci 0000:01:00.0: qca9984/qca9994 hw1.0 target 0x01000000 chip_id 0x00000000 sub 168c:cafe
[  212.260404] ath10k_pci 0000:01:00.0: kconfig debug 1 debugfs 1 tracing 0 dfs 0 testmode 0
[  212.276604] ath10k_pci 0000:01:00.0: firmware ver 10.4-ct-9984-fH-011-cf79c7f api 5 features peer-flow-ctrl,txstatus-noack,wmi-10.x-CT,ratemask-CT,regdump-CT,txrate-CT,flush-all-CT,pingpong-CT,ch-regs-CT,nop-CT,htt-mgt-CT,set-special-CT,cust-stats-CT crc32 a58c7417
[  213.743792] ath10k_pci 0000:01:00.0: board_file api 2 bmi_id 0:31 crc32 85498734
[  217.861761] ath10k_pci 0000:01:00.0: firmware crashed! (uuid fdfb8c74-edf1-4812-95e7-2c02f65594b6)
[  217.861821] ath10k_pci 0000:01:00.0: qca9984/qca9994 hw1.0 target 0x01000000 chip_id 0x00000000 sub 168c:cafe
[  217.869746] ath10k_pci 0000:01:00.0: kconfig debug 1 debugfs 1 tracing 0 dfs 0 testmode 0
[  217.883282] ath10k_pci 0000:01:00.0: firmware ver 10.4-ct-9984-fH-011-cf79c7f api 5 features peer-flow-ctrl,txstatus-noack,wmi-10.x-CT,ratemask-CT,regdump-CT,txrate-CT,flush-all-CT,pingpong-CT,ch-regs-CT,nop-CT,htt-mgt-CT,set-special-CT,cust-stats-CT crc32 a58c7417
[  217.890010] ath10k_pci 0000:01:00.0: board_file api 2 bmi_id 0:31 crc32 85498734
[  217.911297] ath10k_pci 0000:01:00.0: htt-ver 0.0 wmi-op 6 htt-op 4 cal pre-cal-file max-sta 32 raw 0 hwcrypto 1
[  217.920791] ath10k_pci 0000:01:00.0: firmware register dump:
[  217.928569] ath10k_pci 0000:01:00.0: [00]: 0x01000000 0x000015B3 0x009CBC16 0x00975B31
[  217.934469] ath10k_pci 0000:01:00.0: [04]: 0x009CBC16 0x00060530 0x00000011 0x004188B0
[  217.942104] ath10k_pci 0000:01:00.0: [08]: 0x00417618 0x00400000 0x004069B0 0x00423070
[  217.950089] ath10k_pci 0000:01:00.0: [12]: 0x00000009 0xFFFFFFFF 0x00973B25 0x00973B47
[  217.957992] ath10k_pci 0000:01:00.0: [16]: 0x009CBC16 0x000CAFD8 0x00000000 0x00000000
[  217.965896] ath10k_pci 0000:01:00.0: [20]: 0x409CBC16 0x004068EC 0x00000001 0x00403628
[  217.973701] ath10k_pci 0000:01:00.0: [24]: 0x8098050C 0x0040694C 0x0000003C 0xC09CBC16
[  217.981672] ath10k_pci 0000:01:00.0: [28]: 0x800DC4E5 0x004069AC 0x00000004 0x00414D90
[  217.989576] ath10k_pci 0000:01:00.0: [32]: 0x800C383A 0x004069DC 0x0002DB29 0x00400000
[  217.997480] ath10k_pci 0000:01:00.0: [36]: 0x809800A3 0x00406A0C 0x00414D10 0x009C03F4
[  218.005383] ath10k_pci 0000:01:00.0: [40]: 0x8098003A 0x00406A5C 0x00400000 0x00400600
[  218.013198] ath10k_pci 0000:01:00.0: [44]: 0x809607C1 0x00406A8C 0xD8400100 0x00406A9C
[  218.021191] ath10k_pci 0000:01:00.0: [48]: 0x80960892 0x00406AAC 0x00000000 0x00000008
[  218.029063] ath10k_pci 0000:01:00.0: [52]: 0x80960E39 0x00406ACC 0x00400000 0x00400600
[  218.036967] ath10k_pci 0000:01:00.0: [56]: 0x80960E9D 0x00406AEC 0x00000000 0x00400600
[  218.044871] ath10k_pci 0000:01:00.0: Copy Engine register dump:
[  218.052698] ath10k_pci 0000:01:00.0: [00]: 0x0004a000   6   6   7   6
[  218.058589] ath10k_pci 0000:01:00.0: [01]: 0x0004a400  11  11  10  11
[  218.065182] ath10k_pci 0000:01:00.0: [02]: 0x0004a800   0   0 127   0
[  218.071533] ath10k_pci 0000:01:00.0: [03]: 0x0004ac00   0   0   0   0
[  218.078052] ath10k_pci 0000:01:00.0: [04]: 0x0004b000   0   0   0   0
[  218.084457] ath10k_pci 0000:01:00.0: [05]: 0x0004b400   0   0   0   0
[  218.090803] ath10k_pci 0000:01:00.0: [06]: 0x0004b800   0   0   0   0
[  218.097295] ath10k_pci 0000:01:00.0: [07]: 0x0004bc00   1   1   1   1
[  218.103651] ath10k_pci 0000:01:00.0: [08]: 0x0004c000   0   0 127   0
[  218.110166] ath10k_pci 0000:01:00.0: [09]: 0x0004c400   1   1   1   1
[  218.116573] ath10k_pci 0000:01:00.0: [10]: 0x0004c800   0   0   0   0
[  218.122924] ath10k_pci 0000:01:00.0: [11]: 0x0004cc00   0   0   0   0
[  218.131464] ath10k_pci 0000:01:00.0: debug log header, dbuf: 0x96068c  dropped: 4197376
[  218.136858] ath10k_pci 0000:01:00.0: [0] next: 0x0 buf: 0x0 sz: 0 len: 0 count: 0 free: 0
[  218.886372] ath10k_pci 0000:01:00.0: failed to receive control response completion, polling..
[  219.922343] ath10k_pci 0000:01:00.0: ctl_resp never came in (-110)
[  219.922383] ath10k_pci 0000:01:00.0: failed to connect to HTC: -110
[  220.010952] ath10k_pci 0000:01:00.0: could not init core (-110)
[  220.011267] ath10k_pci 0000:01:00.0: could not probe fw (-110)
root@OpenWrt:/# [  220.054035] ath10k_pci 0000:01:00.0: cannot restart a device that hasn't been started