How to assign WAN to LAN on D-Link DAP-2695

Installing and Using OpenWrt
1

Greetings,
can someone help me to assigne WAN to LAN on this D-Link DAP-2695 device?
It only has 2 ports.
And only one really seem to actually work as LAN.
Since I will use it as a Dumb AP, I dont need WAN nor FW....
But I need to pass over the network to the next AP. Therefore I need 2 LAN ports.

Thanks for the help

2

Hi,
Is it the wrong forum section for this question?
Please, advice me the correct place to post this question.
Thank you

3

Greetings,
can someone help me to assigne WAN to LAN on this D-Link DAP-2695 device?
It only has 2 ports.
And only one really seem to actually work as LAN.
Since I will use it as a Dumb AP, I dont need WAN nor FW....
But I need to pass over the network to the next AP. Therefore I need 2 LAN ports.

Thanks for the help
PS
I posted the same question in a different category section. I assume it was the wrong category. Therefore I post it here again with more hope.

4

You haven't received a reply the first time, because it is device and software version specific and probably no one who can help is familiar with your device.

You can take some ideas from here, or post the network configuration file.

2 Likes
5

thanks.
Such a pity. It seem to be a pretty good device as a AP extension with PoE.

6

Sorry, my answer made little sense.. I have 2 posts for same device and I confused the subject...
I will look up your reference...

7

You may have better luck getting additional quality responses if you improve your original post by adding the contents of your /etc/config/network file.

1 Like
8

I will do that as soon I turn that on again to work on it.
Thanks