Hi,
Some one give this Wifi AP to me to repair and reinstall firmware already its bricked by installing wrong openwrt can you please specify uart pins to connect serial console?
which pins are RX, TX, GND and VCC ?
also if anyone got any information about this board could be help to me MODEL=G31W-L_V1.0
behind board:
--> Product ?
its a NoName device, no brand on front or back panels
one the underside... the four pins near the edge with the breakout circle pads ( near the center of the leds ) look promising...
multimeter on ohms to another ground @ 0ish ohm = ground
see https://openwrt.org/docs/techref/hardware/port.serial#finding_serial_console
