Firewall 4 Status

Hostname	OpenWrt
Model	Linksys WRT1900ACS
Architecture	ARMv7 Processor rev 1 (v7l)
Target Platform	mvebu/cortexa9
Firmware Version	OpenWrt SNAPSHOT r18549-2d19e6c6a4 / LuCI Master git-22.006.47037-48599d8
Kernel Version	5.10.90
Protocol: PPPoE+ ipv6 all ok

I just installed the latest version of openwrt snapshot with firewall4, I notice that nothing is displayed in the firewall status menu .
We need to made some rules in the dedicated firewall menu ?

1 Like

Status display is not yet supported for fw4.


on the speed test side it handles better I see an improvement if I activate Software flow offloading + Packet Steering ,with command top in the command line I see sirq of 44% 899 downloads and uploud 900 Mbps

if I disable Software flow offloading sirq goes to 89% with lower performance

it handles pretty well and in speed test using ipv6, I am from Romania and this server is in Germany

1 Like

this morning I found my router without access to the web interface and with the internet down, I think the fault is due to the firewall4 !

at the moment I have switched to a standard firewall version , everything seems ok

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.