Disable firewall and open all ports

[mrbyte]

Hello!!
I would like to disable the firewall and open all the ports. In the wan side of the router I have a Sophos, so I'll be fine.
Is the easiest way going to System > Startup and stop the service & disable the firewall script? I understand that after a reboot the firewall should be disabled.

Is this correct?

Thank you very much and best regards!!

[psherman]

Do you have stuff downstream of the OpenWrt router? Is the goal to reach stuff downstream of the router, or just the router itself?

[mrbyte]

Hello!!
That's the point, I need to route some traffic from the wan side where I have a Proxmox with some VM to the LAN side where I have another Proxmox deployed.

Here is a basic diagram of my setup:

Problems to route traffic from WAN to LAN

Best regards!!

[psherman]

Can you confirm that you are using a GL-inet router with the stock firmware?

ubus call system board

[mrbyte]

Hello!!
Yes, my router is a GL.iNet:

Best regards!!

[psherman]

You'll need to stick with your request on the GL-inet forums. That device is not supported by the official OpenWrt project, and GL-inet makes major modifications to their firmware such that it does not operate the same way as official OpenWrt does. That makes it unsupportable here because we don't know the nuances of how things have been changed... only they (and their user forums) have that knowledge.

[mrbyte]

Hello!!
Ok, understood, thanks for the info.

Best regards!!