I have managed to install OpenWrt 25.12.0 on my TP-Link RE650 v1.
It receives its internet connection via the LAN port.
I have also configured a WireGuard interface on the device. It is up and running, being that TX and RX values are populated.
I have created a SSID, and is getting internet service from it.
My ultimate wish, is to have the WiFi uitilise the WireGuard connection.
Basically, I wish to have the RE650 device operate like a regular router.
I have noticed that, on a regular router, there are wan interfaces, that are automatically created, to handle the internet connection. The RE650 device only has a LAN interface.
I have tried the methods included in the PDF to no avail.
I have noticed two particular differences, between the GUI in the tutorials, and the one on my device:
After creating the bridged guest device, my RX value remains at 0, obviously indicating no sign of communications.
There is no wan interface on the TP-Link RE650 by default. I get a wan interface, whenever I use the device in repeater mode, and setup the wireless connection.
In the end though, is it possible to upload a configuration, to the point where I have reached, and have it corrected, to work as desired?
Ok guys listen up. I came across a video on YouTube, and this guy is the best. He gave the full config instructions, step-by-step, even to the point of isolating your guest network traffic from your main network traffic.