Bonjour,
the alix2d3 is reported to be supported, but neither the current 18.06.1 image nor the nightly snapshot seem to be feasable to boot up on alix. Any ideas to get it working or any reports of an successful installation?
I have downloaded the 18.06.1 image (as well as a curren snapshot) form openwrt.org and flashed it cf using dd.
The serial output reports a successful start of vmlinuz but does not report the termination of the boot process. No ethX devices are reported. As a consequence none of the three ports are reachable under 192.168.1.1.
Any ideas?
Cheers
Daniel
Oh and here the boot log for the bold of you:
[ 0.000000] Linux version 4.14.81 (buildbot@6167ddb9a6c5) (gcc version 7.3.0 (OpenWrt GCC 7.3.0 r8467-dd02a19)) #0 Sat Nov 17 15:27:38 2018
[ 0.000000] x86/fpu: x87 FPU will use FSAVE
[ 0.000000] e820: BIOS-provided physical RAM map:
[ 0.000000] BIOS-e820: [mem 0x0000000000000000-0x000000000009ffff] usable
[ 0.000000] BIOS-e820: [mem 0x00000000000f0000-0x00000000000fffff] reserved
[ 0.000000] BIOS-e820: [mem 0x0000000000100000-0x000000000fffffff] usable
[ 0.000000] BIOS-e820: [mem 0x00000000fff00000-0x00000000ffffffff] reserved
[ 0.000000] Notice: NX (Execute Disable) protection missing in CPU!
[ 0.000000] DMI not present or invalid.
[ 0.000000] tsc: Fast TSC calibration using PIT
[ 0.000000] e820: last_pfn = 0x10000 max_arch_pfn = 0x100000
[ 0.000000] MTRR: Disabled
[ 0.000000] x86/PAT: MTRRs disabled, skipping PAT initialization too.
[ 0.000000] x86/PAT: Configuration [0-7]: WB WT UC- UC WB WT UC- UC
[ 0.000000] ACPI: Early table checksum verification disabled
[ 0.000000] ACPI BIOS Error (bug): A valid RSDP was not found (20170728/tbxfroot-244)
[ 0.000000] 0MB HIGHMEM available.
[ 0.000000] 256MB LOWMEM available.
[ 0.000000] mapped low ram: 0 - 10000000
[ 0.000000] low ram: 0 - 10000000
[ 0.000000] Zone ranges:
[ 0.000000] DMA [mem 0x0000000000001000-0x0000000000ffffff]
[ 0.000000] Normal [mem 0x0000000001000000-0x000000000fffffff]
[ 0.000000] HighMem empty
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x0000000000001000-0x000000000009ffff]
[ 0.000000] node 0: [mem 0x0000000000100000-0x000000000fffffff]
[ 0.000000] Initmem setup node 0 [mem 0x0000000000001000-0x000000000fffffff]
[ 0.000000] Using APIC driver default
[ 0.000000] No local APIC present or hardware disabled
[ 0.000000] APIC: disable apic facility
[ 0.000000] APIC: switched to apic NOOP
[ 0.000000] e820: [mem 0x10000000-0xffefffff] available for PCI devices
[ 0.000000] clocksource: refined-jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[ 0.000000] random: get_random_bytes called from start_kernel+0x68/0x379 with crng_init=0
[ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 64927
[ 0.000000] Kernel command line: BOOT_IMAGE=/boot/vmlinuz root=PARTUUID=7a73246a-02 rootfstype=ext4 rootwait console=tty0 console=ttyS0,115200n8 noinitrd
[ 0.000000] PID hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
[ 0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
[ 0.000000] Initializing CPU#0
[ 0.000000] Initializing HighMem for node 0 (00000000:00000000)
[ 0.000000] Memory: 252492K/261756K available (4397K kernel code, 290K rwdata, 1432K rodata, 384K init, 288K bss, 9264K reserved, 0K cma-reserved, 0K highmem)
[ 0.000000] virtual kernel memory layout:
[ 0.000000] fixmap : 0xfffa4000 - 0xfffff000 ( 364 kB)
[ 0.000000] cpu_entry : 0xffc00000 - 0xffc28000 ( 160 kB)
[ 0.000000] pkmap : 0xff800000 - 0xffc00000 (4096 kB)
[ 0.000000] vmalloc : 0xd0800000 - 0xff7fe000 ( 751 MB)
[ 0.000000] lowmem : 0xc0000000 - 0xd0000000 ( 256 MB)
[ 0.000000] .init : 0xc1608000 - 0xc1668000 ( 384 kB)
[ 0.000000] .data : 0xc144b5a0 - 0xc15fe900 (1740 kB)
[ 0.000000] .text : 0xc1000000 - 0xc144b5a0 (4397 kB)
[ 0.000000] Checking if this processor honours the WP bit even in supervisor mode...Ok.
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS: 2304, nr_irqs: 32, preallocated irqs: 16
[ 0.000000] Console: colour dummy device 80x25
[ 0.000000] console [tty0] enabled
[ 0.000000] console [ttyS0] enabled
[ 0.010000] tsc: Fast TSC calibration using PIT
[ 0.020000] tsc: Detected 498.068 MHz processor
[ 0.020000] Calibrating delay loop (skipped), value calculated using timer frequency.. 996.13 BogoMIPS (lpj=4980680)
[ 0.030015] pid_max: default: 32768 minimum: 301
[ 0.040231] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.046878] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.050761] Last level iTLB entries: 4KB 0, 2MB 0, 4MB 0
[ 0.060016] Last level dTLB entries: 4KB 0, 2MB 0, 4MB 0, 1GB 0
[ 0.065956] CPU: Geode(TM) Integrated Processor by AMD PCS (family: 0x5, model: 0xa, stepping: 0x2)
[ 0.070021] Spectre V2 : Spectre mitigation: LFENCE not serializing, switching to generic retpoline
[ 0.080011] Spectre V2 : Mitigation: Full generic retpoline
[ 0.090011] Spectre V2 : Spectre v2 / SpectreRSB mitigation: Filling RSB on context switch
[ 0.100012] Speculative Store Bypass: Vulnerable
[ 0.105341] Performance Events: no PMU driver, software events only.
[ 0.111780] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[ 0.120024] futex hash table entries: 256 (order: -1, 3072 bytes)
[ 0.130095] pinctrl core: initialized pinctrl subsystem
[ 0.136385] NET: Registered protocol family 16
[ 0.141398] cpuidle: using governor ladder
[ 0.145831] clocksource: pit: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 1601818034827 ns
[ 0.151813] PCI: PCI BIOS revision 2.10 entry at 0xfcc2b, last bus=0
[ 0.160014] PCI: Using configuration type 1 for base access
[ 0.192883] ACPI: Interpreter disabled.
[ 0.197250] SCSI subsystem initialized
[ 0.200883] usbcore: registered new interface driver usbfs
[ 0.206477] usbcore: registered new interface driver hub
[ 0.210079] usbcore: registered new device driver usb
[ 0.215385] dmi: Firmware registration failed.
[ 0.220013] PCI: Probing PCI hardware
[ 0.223827] PCI host bridge to bus 0000:00
[ 0.230028] pci_bus 0000:00: root bus resource [io 0x0000-0xffff]
[ 0.236247] pci_bus 0000:00: root bus resource [mem 0x00000000-0xffffffff]
[ 0.240021] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
[ 0.250120] pci 0000:00:01.0: [Firmware Bug]: reg 0x10: invalid BAR (can't size)
[ 0.262612] pci 0000:00:0f.2: legacy IDE quirk: reg 0x10: [io 0x01f0-0x01f7]
[ 0.269789] pci 0000:00:0f.2: legacy IDE quirk: reg 0x14: [io 0x03f6]
[ 0.270023] pci 0000:00:0f.2: legacy IDE quirk: reg 0x18: [io 0x0170-0x0177]
[ 0.280023] pci 0000:00:0f.2: legacy IDE quirk: reg 0x1c: [io 0x0376]
[ 0.296109] clocksource: Switched to clocksource pit
[ 0.296109] pnp: PnP ACPI: disabled
[ 0.304867] NET: Registered protocol family 2
[ 0.310216] TCP established hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.317303] TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.323717] TCP: Hash tables configured (established 2048 bind 2048)
[ 0.330217] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.336145] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.342609] NET: Registered protocol family 1
[ 0.357772] platform rtc_cmos: registered platform RTC device (no PNP device found)
[ 0.369199] alix: system is recognized as "PC Engines ALIX.2 v0.98"
[ 0.375813] NatSemi SCx200 Driver
[ 0.381985] workingset: timestamp_bits=30 max_order=16 bucket_order=0
[ 0.397333] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.413571] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 251)
[ 0.421099] io scheduler noop registered
[ 0.425102] io scheduler deadline registered (default)
[ 0.432207] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled
[ 0.449368] serial8250: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16550A
[ 0.459818] Non-volatile memory driver v1.3
[ 0.464186] AMD Geode RNG detected
[ 0.467711] platform pc8736x_gpio.0: NatSemi pc8736x GPIO Driver Initializing
[ 0.474948] platform pc8736x_gpio.0: no device found
[ 0.484845] loop: module loaded
[ 0.488338] cs5535-gpio cs5535-gpio: reserved resource region [io 0x6100-0x61ff]
[ 0.496275] cs5535-mfgpt cs5535-mfgpt: reserved resource region [io 0x6200-0x623f]