Need help to porting new device Netis NX10. This is budget WiFi 6 router.
Can access ssh terminal via root user and web password.
Hardware Platform:
CPU: MIPS 24Kc (RTL8197F)
Flash: 16MB
RAM: 128MB
Switch Chip: RTL8367D
Processor: 1GHz CPU
DDR/FLASH: 128MB/16MB
Interface: 1* Gigabit WAN Port+3*Gigabit LAN Ports
Buttons: WPS/MESH, RESET
cat /proc/mtd
dev: size erasesize name
mtd0: 00370000 00010000 "boot+cfg+linux"
mtd1: 00b90000 00010000 "rootfs"
mtd2: 00020000 00010000 "netis"
mtd3: 00060000 00010000 "jffs2 file"
cat /proc/partitions
major minor #blocks name
1 0 4096 ram0
1 1 4096 ram1
1 2 4096 ram2
1 3 4096 ram3
1 4 4096 ram4
1 5 4096 ram5
1 6 4096 ram6
1 7 4096 ram7
1 8 4096 ram8
1 9 4096 ram9
1 10 4096 ram10
1 11 4096 ram11
1 12 4096 ram12
1 13 4096 ram13
1 14 4096 ram14
1 15 4096 ram15
31 0 3520 mtdblock0
31 1 11840 mtdblock1
31 2 128 mtdblock2
31 3 384 mtdblock3
TFTP server enabled if firmware upgrade failed or powered on with reset button pressed. (server ip: 192.168.1.6) accept firmware with any name.
Where to start? RTL8197F has not sufficient support in forum.