ath wrote:Buona fortuna
It's been tricky repartitoining the mtd with adam2 but i was very "fortunato", and everything works now. I've got trunk r16776 running on Dlink DSL-524T.
This modem always used to be hot, but when i opened it i found that both the cpu and the switch were the hottest chip i've ever touched... Dlink, a couple of heatsink are too expensive?!
Anyway, the DSL line syncs but i've no ppp0 interface or anything like that... what i'm missing?
This is my ifconfig output:
root@DSL-524T:~# ifconfig
br-lan Link encap:Ethernet HWaddr 00:17:9A:B7:92:D6
inet addr:192.168.2.1 Bcast:192.168.2.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 MThis is etric:1
RX packets:347 errors:0 dropped:0 overruns:0 frame:0
TX packets:234 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:27793 (27.1 KiB) TX bytes:23129 (22.5 KiB)
eth0 Link encap:Ethernet HWaddr 00:17:9A:B7:92:D6
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1041 errors:0 dropped:0 overruns:0 frame:0
TX packets:698 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:80652 (78.7 KiB) TX bytes:61456 (60.0 KiB)
Interrupt:41
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:74 errors:0 dropped:0 overruns:0 frame:0
TX packets:74 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4954 (4.8 KiB) TX bytes:4954 (4.8 KiB)
dmesg:
...
registered device TI Avalanche SAR
Sangam detected
requesting firmware image "ar0700xx.bin"
firmware: requesting ar0700xx.bin
avsar firmware released
tn7dsl_set_modulation : Setting mode to 0xffff
Creating new root folder avalanche in the proc for the driver stats
Texas Instruments ATM driver: version:[7.03.01.00]
DSL in Sync
...
root@DSL-524T:~# cat /proc/net/dev
Inter-| Receive | Transmit
face |bytes packets errs drop fifo frame compressed multicast|bytes packets errs drop fifo colls carrier compressed
lo: 8218 122 0 0 0 0 0 0 8218 122 0 0 0 0 0 0
eth0: 208072 2510 0 0 0 0 0 0 289935 1972 0 0 0 0 0 0
eth1: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
br-lan: 37575 534 0 0 0 0 0 23 78673 437 0 0 0 0 0 0
I tried to configure the wan interface with pppoa, but i don't know what to put under "ifname" option...
I hope it's some stupid thing i'm missing... and what eth1 is???
ath, thanks for the tips...
Bye