how do i revert back to stock firmware again, i want the netgear web gui
Topic: ex2700
The content of this topic has been archived on 13 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Most Netgear models have TFTP recovery. Hold down the reset button while plugging in the power. Keep holding the button for some time until the power LED finally starts flashing green slowly. Using a TFTP client on your PC, TFTP a stock firmware to 192.168.1.1 through the Ethernet port.
i did that, i get unable to get response from the server
The discussion might have continued from here.
Page 1 of 1