starcms wrote:I'd recommend keeping radio2 disabled. radio0 is your main 5ghz AP and radio1 is your 2.4ghz AP.
Reasonable, but wrong:
root@TTrollstation:/tmp# lspci 00:01.0 PCI bridge: Marvell Technology Group Ltd. MV78230 [Armada XP] ARM SoC (rev 02) 00:02.0 PCI bridge: Marvell Technology Group Ltd. MV78230 [Armada XP] ARM SoC (rev 02) 00:03.0 PCI bridge: Marvell Technology Group Ltd. MV78230 [Armada XP] ARM SoC (rev 02) 01:00.0 USB controller: Etron Technology, Inc. EJ168 USB 3.0 Host Controller (rev 01) 02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88W8864 [Avastar] 802.11ac Wireless 03:00.0 Ethernet controller: Marvell Technology Group Ltd. 88W8864 [Avastar] 802.11ac Wireless
So wireless is pci 2 and 3. It's 1900AC, BTW, maybe 3200 have different set.
The 1900AC V1 is very different from all others. What I posted is correct for all other models (minus the radio2, which only applies to the 3200ACM).
Edit: This is from my 1200AC. All models are the same, except the 1900AC V1 which is completely different (because it uses the Marvell Armada XP MV78230 SoC instead of the Marvell Armada 385 88F6820), and the 3200ACM which can have an entry for radio2 at 03:00.0 for the 88W8887 (and has the 88W8964 instead of the 88W8864 for radio0 and radio1 at 01:00.0 and 02:00.0, respectively).
root@WRT1200AC:~# lspci
00:01.0 PCI bridge: Marvell Technology Group Ltd. Device 6820 (rev 04)
00:02.0 PCI bridge: Marvell Technology Group Ltd. Device 6820 (rev 04)
01:00.0 Ethernet controller: Marvell Technology Group Ltd. 88W8864 [Avastar] 802.11ac Wireless
02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88W8864 [Avastar] 802.11ac Wireless
Edit2: In your original post, you were responding to someone who had a 3200ACM, hence why I thought you also had one, not a 1900AC V1.
(Last edited by starcms on 17 May 2017, 16:49)