Hello guys!
I've been following the tutorials here, but I still can not get remote access either through port 80 or 443. If you can help me, some instruction on something I did not see? Below my settings.
Model: TP-Link TL-WR1043N/ND v1
Firmware: OpenWrt Chaos Calmer 15.05.1
/etc/config/firewal
config zone
option input 'ACCEPT'
option output 'ACCEPT'
option name 'wan_pppoe'
option network 'WAN'
option forward 'ACCEPT'
option masq '1'
option mtu_fix '1'
config forwarding
option dest 'lan'
option src 'wan_pppoe'
config forwarding
option dest 'wan_pppoe'
option src 'lan'
config rule
option target 'ACCEPT'
option proto 'tcp udp'
option src 'wan_pppoe'
option enabled '0'
config rule
option name 'luci-wan'
option target 'ACCEPT'
option proto 'tcp'
option dest_port '443 80'
option src 'wan_pppoe'
config redirect
option _name 'luci-wan-redirect'
option src 'wan_pppoe'
option proto 'tcp'
option dest 'lan'
option src_dport '4443'
option dest_port '443'
config redirect
option _name 'luci-wan-redirect'
option src 'wan_pppoe'
option proto 'tcp'
option dest 'lan'
option src_dport '8088'
option dest_port '80'