OpenWrt Forum Archive

Topic: Problem after update

The content of this topic has been archived on 20 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hello everybody, i don't know if is the right place for doing this but, i can't find an answear for this

i have a TP-Link WDR4300 using openwrt and i used this site for restore the original firmware.


but now when i acess the router page, just show the black screen with written in white "LuCI - Lua configuration interface", after that show an error "timed out"

i can't enter in failsafe mode and i tryied using TFTP

but nothing changes
what i can do for restore? sorry about my english...

this site friedzombie com / tplink-stripped-firmware

Login with SSH

i can't understand how i do this command
" publish a firmware image via tftp: cp openwrt-ar71xx-generic-tl-wdr4300-v1-squashfs-factory.bin /srv/tftp/wdr4300v1_tp_recovery.bin "

Acess via SSH don't requires failsafe mode?

when i try to ping 192.168.0.86
"destiny host inacessible"

i tryed this tutorial
forum.tp-link com/showthread.php?81462-How-to-recovery-the-router-when-you-bricked-it

but nothing changes

Assuming the stock TP-Link firmware loaded properly, you are likely seeing the "LuCI" page from your browser's cache.  Clear the browser cache.

Stock firmware should respond to ping and http to 192.168.0.1.  There is no ssh in stock firmware.

Oh many thanks, clearing the cache fix it
seriously many thanks <3
I was worried that i can't use this again

The discussion might have continued from here.