I install the package luci-app-mmc-over-gpio
I get web interface that allows me to select the pins for DI,DO,CLK,CS.
I have connected SD card with 4 free gpios (GPIO#7,#9,#11,#13) of RT5350 chipset.
DI=7, DO=9, CLK=13, CS=11.
These GPIOs are of UARTF port. They are DTR_N,RTS_N,DSR_N,CTS_N.
UARTF is in GPIO mode as I dumped the register GPIOMODE (0x1000_0060). It is defined as gpio in .dts file as below:
pinctrl {
state_default: pinctrl0 {
gpio {
ralink,group = "i2c", "jtag", "uartf";
ralink,function = "gpio";
};
};
};
Currently, getting the below error in dmesg:
gpiommc gpiommc.0: no of_node; not parsing pinctrl DT
gpio-mmc: Failed to request mmc_spi module.
spi-gpio spi-gpio.0: no of_node; not parsing pinctrl DT
rt2880-pinmux pinctrl: request pin 13 (io13) for pio:13
spi-gpio: probe of spi-gpio.0 failed with error -16
gpio-mmc: MMC-Card "default1" attached to GPIO pins di=7, do=9, clk=13, cs=11
Any clues about this error?
Thanks,
(Last edited by pradeepsysargus on 27 Sep 2016, 06:32)