Hi,
I'm trying to de-brick TP-LINK WR841ND 8.1 . On cable Nokia DKU-5 I'm able to type/send data, but there are too many errors during transfer, whenever I switch data to anything else then 115200 speed, I get garbage only.
When I use cable CP2102 USB 2.0 to TTL UART cable (http://www.aliexpress.com/item/CP2102-U … .55.nsarG4) , on speed 128000 I'm getting 100% clear output but the console is read only.
I have tried 10 kOhm resistor between VCC and RX - no change. I was searching for R26 resistor, didn't found it. (should be anyway applicable for 8.1). I was changing PINs RX/TX if they are not switched - no change.
Any idea please what is wrong please ?