Hello
I have the exact box as shown in this link
http://wiki.openwrt.org/toh/audiocodes/ … uwiki__top
I have few questions and I hope that you can answer and/or forward me to the correct person :-)
I got this box when I used to have a phone line from the ISP few years ago,
and it has been sitting in my "junk" box till now when I got a new SIP line
and I remembered that it can be used to connect to a SIP account.
however I don't have the ADMIN password for it and RESET button in the back does not help
since it still loads the ISP firmware.
I talked with them and they no longer support this box and have no way to unlock it for me.
so I searched the internet till i found the link above and took the box apart
with the hope to put a new firmware and us it.
BUT
1. I have setup a SERIAL Female DB9 connector on the serial com port as shown in the picture
but no matter which baud speed I use from 9600 to 115200 with or without negotiations
all i get on the terminal screen is gibberish characters.
my question is what is the correct settings and DB9 pinout currently 2,3,5 are used (7 does not change anything) ?
2. is there any other way to reset the box to its factory defaults ?
3. I can't find any documentation on how to change the firmware and from where to download it.
please help me get started.
thank You
Avi