Are pvid of a switch port supported by ChaosCalmer nowadays ???
I try to configure a pvid for a port as following:
"swconfig dev switch0 port 0 set pvid 43"
I got nothing of response, and it seemed success.
But in fact nothing had been changed, when I check the configuration by using following command:
" swconfig dev switch0 port 0 show"
Port 0:
disable: 0
doubletag: 0
untag: 0
led: 5
lan: 1
recv_bad: 0
recv_good: 9566
tr_bad: ???
tr_good: ???
pvid: 0
link: port:0 link:up speed:100baseT full-duplex
How can I set a pvid for a port ?
Would anyone please like to help me ?
thanks!
(Last edited by evilroach on 6 Oct 2015, 20:19)