OpenWrt Forum Archive

Topic: OpenWRT on Archer C7 - no acces port 80

The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hi all,

I flashed my router by OpenWRT firmware. But now I can´t connect via web browser: http://192.168.1.1

I Have pinged 192.168.1.1  (my IP adress is 192.168.1.2 and lan cable have pluged to WAN port)

I can change pswd via telnet 192.168.1.1
I can reset to default setting via telnet 192.168.1.1
I can connect to my router via SSH

But I still can´t connect to my router via web browser.

Any a piece of good advice? THX

(Last edited by Prescott on 1 Sep 2015, 15:11)

Which firmware image did you flash to your router?

http://wiki.openwrt.org/about/latest#bleeding_edge

"Prebuilt trunk images do not come with any web interface or GUI. You will need to be comfortable using a command line and remote shell to install one yourself: LuCI Essentials"

No GUI -> most probably no webserver enabled

Thank you very much. I finaly understand and it help a lot. But I have another issue which I´m going to solving in another thread. Sorry for my english. roll

(Last edited by Prescott on 4 Sep 2015, 22:13)

The discussion might have continued from here.