Trying to upgrade my D-Link DSL-502T with kamikaze latest version (been unsure if this is appropriate but I've been going with it) sourced from here http://downloads.openwrt.org/kamikaze/8 … uashfs.bin and having problems. Downloaded adam2flash-502T.pl script and ran it, and got this:

$ ./adam2flash-502T.pl 192.168.1.1 -setmtd1 ~/Downloads/openwrt-ar7-squashfs.bin
Looking for device: ……… found!
ADAM2 version 0.22.2 at 192.168.1.1 (192.168.1.1)
Firmware type: OpenWRT (little-endian)
logging into ADAM2 bootloader.. ok.
checking hardware.. AR7RD / DSL-502T.
checking MTD settings.. MTD4 was not as expected (should be ’0×90010000,0x903f0000?, was ’0×90020000,0x903e0000?). Cowardly refusing to do anything about it! at ./adam2flash-502T.pl line 270.

Furthermore, it behaves strangely afterwards, requiring power to be cycled from the power point.
What’s going on, and how do I begin to get it going?

I found this https://forum.openwrt.org/viewtopic.php?id=21315 - it implies my adam2flash script needs alteration but am unsure if I'm the best person to alter the adam2flash for my Gen II.

I am new to linux fedora 16 .Please can any one  show me how to run this script adam2flash-502t.pl.