OpenWrt Forum Archive

Topic: Inteno DG301B

The content of this topic has been archived on 31 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Starting a topic for this.

Added information on this page:
http://wiki.openwrt.org/toh/inteno/dg301b

Its already running OpenWRT, but would be nice with a clean OpenWRT build on it.

here is some problems could be to use this board on clean OpenWRT.
NAT: iopsys use hardware NAT, it more faster than typical OpenWRT on processor NAT.(max could be 300-400mbps)
DSL: Broadcom does not give driver source.

Putting the DSL files manually will fix the DSL driver problem i guess.

Hello!

I'm not proficient in WRT compiling etc. Can anyone share working OpenWRT firmware for this device? Just to feed it into firmware upgrade web page on DG301B-R1. It seems like it could be good for me to have PPPoE option for WAN interface, otherwise this device can only work with Eidsiva provider. I need to use it with other provider.

Thanks in advance and best regards.

(Last edited by Artistus on 4 Apr 2017, 13:38)

The discussion might have continued from here.