Hello,
I've done my best to read wiki pages etc but so far not managed to figure out what I've missed.
following the WIKI (http://wiki.openwrt.org/doc/howtobuild/sheevaplug) pages I've downloaded Barrier Breaker R45704 and configured it for my Dreamplug, however no matter what I do the dreamplug fails to complete boot..it seems to hang just after booting the kernel..
I'm trying to boot from a USB stick to start with, but later obviously plan to write it to the internal SD card.
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 8 USB Device(s) found
scanning bus for storage devices... Device NOT ready
Request Sense returned 02 3A 00
3 Storage Device(s) found
Loading file "/boot/uImage" from usb device 2:2 (usbdc2)
1547548 bytes read
## Booting kernel from Legacy Image at 00800000 ...
Image Name: ARM OpenWrt Linux-3.10.49
Created: 2015-05-20 17:58:43 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1547484 Bytes = 1.5 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
Please can someone help me with this?
Thanks
---Guy