sorry...
Linux version 2.6.26.8 (agb@arrakis) (gcc version 4.1.2) #1 Wed Dec 2 15:14:35 UTC 2009
console [early0] enabled
CPU revision is: 00018448 (MIPS 4KEc)
Clocks: Async mode
Clocks: Setting DSP clock
Clocks: prediv: 1, postdiv: 1, mul: 5
Clocks: base = 25000000, frequency = 125000000, prediv = 1, postdiv = 2, postdiv2 = 1, mul = 10
Clocks: Setting CPU clock
Adjusted requested frequency 211000000 to 211968000
Clocks: prediv: 1, postdiv: 1, mul: 6
Clocks: base = 35328000, frequency = 211968000, prediv = 1, postdiv = 1, postdiv2 = -1, mul = 6
Clocks: Setting USB clock
Adjusted requested frequency 48000000 to 48076920
Clocks: prediv: 13, postdiv: 1, mul: 5
Clocks: base = 125000000, frequency = 48000000, prediv = 13, postdiv = 1, postdiv2 = -1, mul = 5
TI AR7 (TNETD7200), ID: 0x002b, Revision: 0x10
Determined physical RAM map:
memory: 01000000 @ 14000000 (usable)
Entering add_active_range(0, 81920, 86016) 0 entries of 256 used
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 81920 -> 86016
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 81920 -> 86016
On node 0 totalpages: 4096
Normal zone: 32 pages used for memmap
Normal zone: 0 pages reserved
Normal zone: 4064 pages, LIFO batch:0
Movable zone: 0 pages used for memmap
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064
Kernel command line: init=/etc/preinit rootfstype=squashfs,jffs2, console=ttyS0,38400n8
Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes.
Primary data cache 8kB, 4-way, VIPT, no aliases, linesize 16 bytes
PID hash table entries: 64 (order: 6, 256 bytes)
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 12560k/16384k available (2001k kernel code, 3824k reserved, 417k data, 124k init, 0k highmem)
SLUB: Genslabs=6, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 211.35 BogoMIPS (lpj=1056768)
Mount-cache hash table entries: 512
net_namespace: 644 bytes
NET: Registered protocol family 16
Switched to high resolution mode on CPU 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
msgmni has been set to 24
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x8610e00 (irq = 15) is a TI-AR7
console handover: boot [early0] -> real [ttyS0]
Fixed MDIO Bus: probed
cpmac-mii: probed
cpmac: device eth0 (regs: 08610000, irq: 27, phy: , mac: 00:18:f8:61:8e:44)
physmap platform flash device: 00800000 at 10000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
physmap-flash.0: Found an alias at 0x400000 for the chip at 0x0
Amd/Fujitsu Extended Query Table at 0x0040
physmap-flash.0: Swapping erase regions for broken CFI table.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
cmdlinepart partition parsing not available
RedBoot partition parsing not available
4 ar7part partitions found on MTD device physmap-flash.0
Creating 4 MTD partitions on "physmap-flash.0":
0x00000000-0x00010000 : "loader"
0x00010000-0x00020000 : "config"
0x00020000-0x00400000 : "linux"
0x000f0000-0x00400000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=290000, len=170000
0x00290000-0x00400000 : "rootfs_data"
ar7_wdt: disabling watchdog timer
ar7_wdt: timer margin 59 seconds (prescale 65535, change 57180, freq 62500000)
Registered led device: status
vlynq0: regs 0x08611800, irq 29, mem 0x04000000
TCP vegas registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 124k freed
Please be patient, while OpenWrt loads ...
Algorithmics/MIPS FPU Emulator v1.5
mini_fo: using base directory: /
mini_fo: using storage directory: /tmp/root
br-lan: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.
device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0) entering forwarding state
PHY: 0:1f - Link is Down
NET: Registered protocol family 8
NET: Registered protocol family 20
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
acx: this driver is still EXPERIMENTAL
acx: reading README file and/or Craig's HOWTO is recommended, visit http://acx100.sf.net in case of further questions/discussion
acx: compiled to use 32bit I/O access. I/O timing issues might occur, such as non-working firmware upload. Report them
acx: running on a little-endian CPU
acx: PCI/VLYNQ module v0.3.37 initialized, waiting for cards to probe...
Not using the 00000009 VLYNQ device's driver for VLYNQ device: 00000000
Not using the 00000029 VLYNQ device's driver for VLYNQ device: 00000000
registered device TI Avalanche SAR
Ohio250(7200/7100A2) detected
requesting firmware image "ar0700xx.bin"
firmware: requesting ar0700xx.bin
avsar firmware released
tn7dsl_set_modulation : Setting mode to 0x1
Creating new root folder avalanche in the proc for the driver stats
Texas Instruments ATM driver: version:[7.03.01.00]
jffs2_scan_eraseblock(): End of filesystem marker found at 0x0
jffs2_build_filesystem(): unlocking the mtd device... done.
jffs2_build_filesystem(): erasing all blocks after the end marker... done.
mini_fo: using base directory: /
mini_fo: using storage directory: /jffs
ar7_wdt: enabling watchdog timer