Hi, everyone I have this nice little board AR9331 based with 8 MB ram and 2Mb flash and vxWorks bootloader. I have already upgraded ram to 16MB and flash to 4Mb.
I know it is not supported and never will be supported by openwrt,
I just have the need to convert it into a CPE type wisp client mode, much like this one:
http://redesoutdoor.intelbras.com.br/pr … n-2-12-dbi
I'm able to run firmware for MR3020 and MR2040 but none of these have wisp features on its firmware and there are not many CPEs on the market with this chipset:
So I'm appealing to you guys for help flashing a third party firmware from the vxworks prompt, I have some experience with redboot and uboot but none with vxworks and so far google has not been able to help.
This is the boot log vxworks:
________ ________ __ __ ____ _ __ ___
|________|| ___ | | | | || \ | || | / /
| | | |___| | __ __ | | | || \| || |/ /
| | | _____| |__ __| | |___ | || |\ || \
|__| |__| |______||__||_| \____||__|\___\
Software Platform for MIPS
Creation date: Jun 18 2013, 12:19:09 (chenyunchuan@tp-link.net)
Copyright(C) 2001-2010 by TP-LINK TECHNOLOGIES CO., LTD.
CPU: AR9330: AP121 Board
CPU freq: 400 MHZ
SDRAM size: 8 MB
ipaddr:192.168.1.1
serverip:192.168.1.100
file:vxWorks.img
Attaching interface lo0... avlUintSearch entry...
avlUintInsert entry...
done
Rx clbufs 768 each of size 1756
eth_rx_netpool_init: allocated, pDmaBuf=0x80637910, buffend = 80782514
ATHRS26: resetting s26
ATHRS26: s26 reset done
eth_rx_netpool_init: done already!
Attached IPv4 interface to mirror unit 0
avlUintSearch entry...
avlUintInsert entry...
Load linux for art failed!!
Press Ctrl+C to stop auto-boot...
0
auto-booting...
Bad Magic Number,FFFFFFFF
Can't load boot file!!
Stop auto-boot...
#
thanks for any help that might put me on the right direction...
Perhaps somebody from brazil can share a flash dump from this wog-212 board
nice day