jow wrote:Not sure what you mean with "only one bridge may have a wifi segment". You can have as many bridges with wifi as you want.
Here is the relevant segment from /e/c/wireless:
config wifi-iface
option device 'radio0'
option mode 'ap'
option encryption 'psk-mixed'
option key '...'
option ssid 'Abo-casa'
option network 'lan'
option wmm '1'
option wds '1'
config wifi-iface
option device 'radio0'
option mode 'ap'
option encryption 'psk-mixed'
option key ...
option ssid 'Abo-guest'
option network 'guest'
option wmm '1'
option wds '1'
Unless I add option ifname 'eth0.3 wlan0-1' to config interface 'guest' in /e/c/network, I will get loads of "DHCP from missing address" entries on the router and the remote end of the bridge (Fonera) will be unconfigured.
jow wrote:The fact that "wlan0-1.sta1" is not automatically joined to the bridge proves exactly my point why you shouldn't put wifi ifnames into the network config. If you use "option network guest" in the wifi-iface which declares the guest ssid then wlan0-1 and all its slave interfaces are automatically put into br-guest as needed.
Ok, now I think I understand your remark. Thing is, I'd like to have:
-physical port 1,2,3 and wifi "Abo-casa" SSID in "lan"
-physical port 4 and wifi "Abo-guest" SSID in "guest"
-both "lan" and "guest" masqueraded to "wan" but no routing or bridging at all between them
Is this possible in a clean way?
EDIT: at the moment, it *is* working, even if the config is wrong.
EDITv2: both "lan" and "guest" should support WDS and, again, at present it works.
(Last edited by aboaboit on 17 Dec 2013, 15:57)