OpenWrt Forum Archive

Topic: TP-Link WR1034ND, ver 1.11 - still need to downgrade with German FW?

The content of this topic has been archived on 20 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hello all.
I just got one of these. I know that with some earlier versions of these it was necessary to flash an old German firmware version in order to replace the bootloader with one that wouldn't turn off the WAN port when you tried to flash OpenWRT. Does anyone know if that's still needed?

BTW, in case it matters the serial number starts with 13xxx

Thanks!

it should not be necessary with AA builds and newer...

Cool! Thanks for the prompt reply.

The discussion might have continued from here.