Hi, I am a newbie.
i have build OpewWRT following this steps http://wiki.openwrt.org/doc/howto/obtai … e.generate
i build completed with PROFILE wa901nd.
and copy xx-wa901nd-vmlinux.bin to flash my TL-WA901ND .
i telnet and use command : (run dd-wrt before)
mtd -r write xx-wa901nd-vmlinux.bin linux
after reboot my my TL-WA901ND is fails.
so i try to connect via serial console http://wiki.openwrt.org/toh/tp-link/tl-wa901nd
this is screen and loop to rResetting...
U-Boot 1.1.4 (Feb 24 2012 - 16:48:46)
AP81 (ar7100) U-boot
DRAM:
sri
32 MB
id read 0x100000ff
flash size 4MB, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
No valid address in Flash. Using fixed address
bsingle_phy = 0
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
Uncompressing Kernel Image ... Error: Bad gzipped data
GUNZIP ERROR - must RESET board to recover
Resetting...
please advise me.
(Last edited by dcoffeenet on 5 Sep 2013, 17:27)