OpenWrt Forum Archive

Topic: Dumb AP and TL-WR740

The content of this topic has been archived on 20 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
da1k
6 Sep 2013, 22:54

Hello,

I want to set up my TL-WR740 as an dumb AP and use also ethernet ports in switch. So I use this: http://wiki.openwrt.org/doc/recipes/dumbap. Because I don't know how this router is build I used  configuration for "For devices with switch and dedicated WAN, e.g. WNDR3700" and after that wireless works like a charm but ethernet ports doesn't want to work (they doesn't receive an IP address). So I used other options but without success. How to configure it to works with wireless and ethernet on the same time?

best regards,

Post #2
nebbia88
6 Sep 2013, 23:40

what was happening with DEFAULT configuration? at least lan ports should work...

Post #3
da1k
6 Sep 2013, 23:43
nebbia88 wrote:

what was happening with DEFAULT configuration? at least lan ports should work...

What do you mean by DEFAULT? If before I started to reconfigure to dumb AP lan ports worked properly.

The discussion might have continued from here.