Hello Group
I know these are very old devices but they are great to get Wii / PVR connected to internet. I have one from a colleague at work but its a brick. I have the buffered JTAG cable ( both home built and TIAO JTAG ) so flashing is normal.
Does any one have a CFE.BIN for the WA840G Version 1.
Does any one have the NVRAM.BIN for the WA840G Version 1.
Following is the tjtag ( 3.01 ) probeonly
==============================================
EJTAG Debrick Utility v3.0.1 Tornado-MOD
==============================================
Probing bus ... Done
Instruction Length set to 5
CPU Chip ID: 00000100011100010000000101111111 (0471017F)
*** Found a Broadcom BCM4702 Rev 1 CPU chip ***
- EJTAG IMPCODE ....... : 00000000100000000000100100001000 (00800908)
- EJTAG Version ....... : 1 or 2.0
- EJTAG DMA Support ... : Yes
- EJTAG Implementation flags: R4k MIPS32
Issuing Processor / Peripheral Reset ... Done
Enabling Memory Writes ... Done
Halting Processor ... Skipped
Clearing Watchdog ... Done
Probing Flash at (Flash Window: 0x1fc00000) ...
Done
Flash Vendor ID: 00000000000000000000000000000001 (00000001)
Flash Device ID: 00000000000000000010001011111001 (000022F9)
*** Found a AMD 29lv320DB 2Mx16 BotB (4MB) Flash Chip ***
- Flash Chip Window Start .... : 1fc00000
- Flash Chip Window Length ... : 00400000
- Selected Area Start ........ : 00000000
- Selected Area Length ....... : 00000000
*** REQUESTED OPERATION IS COMPLETE ***
Regards
Stuart
Topic: Old WA840G CFE.BIN / NVRAM.BIN
The content of this topic has been archived on 16 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1