The content of this topic has been archived on 17 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Can someone please publish pinouts for TP-Link TL-WA701ND V2.1 serial connection using Nokia cable?
The chipset is Atheros ar9931
https://picasaweb.google.com/lh/photo/g … Jy0liipFm0
I connected TX, RX and GND as shown here (but the chipset is different):
http://wiki.openwrt.org/toh/tp-link/tl-wa701nd
Should I use any jumpers or connect 3.3v pin?
(Last edited by Osghaly on 27 Feb 2013, 10:50)
1) do not use vcc pin
2) have you crossed tx and rx?
Thank you so much nebbia88 for your quick response 
Actually It was my fault cause I was using Nokia DKU-2 instead of Nokia CA-42 cable that already has a built in converter from usb to rs232.
I also wonder if I could use a serial cable like this one below without need to use a cable to convert usb to serial?!!
Usb to ttl serial
OR
max232 based (or similar) rs232 to ttl level shifter, connected to classic rs232 port..
Usb to ttl serial
OR
max232 based (or similar) rs232 to ttl level shifter, connected to classic rs232 port..
Aha, I see.. thanks for your help really appreciated.
The discussion might have continued from here.