Here is a boot log from flashed device. (connected over serial.)
Wireless is not working. All other things working good!
If anyone can help me with wireless stuff i would be happy.
its a bcm4312 connected with sdio to the bcm6338
CFE version 1.0.37-12.1 for BCM96338 (32bit,SP,BE)
Build Date: Fri Nov 14 16:18:28 CST 2008 (root@localhost.localdomain)
Copyright (C) 2000-2006 Broadcom Corporation.
Boot Address 0xbfc00000
Initializing Arena.
Initializing Devices.
Parallel flash device: name MX29LV320AB, id 0x22a8, size 4096KB
CPU type 0x29010: 240MHz
Total memory: 16777216 bytes (16MB)
Total memory used by CFE: 0x80401000 - 0x805281D0 (1208784)
Initialized Data: 0x8041D700 - 0x8041F9F0 (8944)
BSS Area: 0x8041F9F0 - 0x804261D0 (26592)
Local Heap: 0x804261D0 - 0x805261D0 (1048576)
Stack Area: 0x805261D0 - 0x805281D0 (8192)
Text (code) segment: 0x80401000 - 0x8041D6F8 (116472)
Boot area (physical): 0x00529000 - 0x00569000
Relocation Factor: I:00000000 - D:00000000
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.159
Gateway IP address :
Run from flash/host (f/h) : h
Default host run file name : 308nfs6358
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 1
Board Id (0-9) : 96338W2
Number of MAC Addresses (1-32) : 11
Base MAC Address : 00:1e:40:db:25:3a
PSI Size (1-64) KBytes : 24
*** Press any key to stop auto run (1 seconds) ***
Auto run second count down: 0
Booting from only image (0xbfc10000) ...
Code Address: 0x80010000, Entry Address: 0x80010000
Decompression OK!
Entry at 0x80010000
Closing network.
Starting program at 0x80010000
[ 0.000000] Linux version 3.6.11 (snakefreak@Snakefreak-AMD) (gcc version 4.6.4 20121106 (prerelease) (Linaro GCC 4.6-2012.11) ) #2 Tue 3
[ 0.000000] Detected Broadcom 0x6338 CPU revision a2
[ 0.000000] CPU frequency is 240 MHz
[ 0.000000] 16MB of RAM installed
[ 0.000000] registering 8 GPIOs
[ 0.000000] board_bcm963xx: Boot address 0xbfc00000
[ 0.000000] board_bcm963xx: CFE version: 1.0.37-12.1
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 00029010 (Broadcom BCM6338)
[ 0.000000] board_bcm963xx: board name: 96338W2
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 01000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x00ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x00ffffff]
[ 0.000000] Reserving 0MB of memory at 0MB for crashkernel
[ 0.000000] Primary instruction cache 16kB, VIPT, 2-way, linesize 16 bytes.
[ 0.000000] Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064
[ 0.000000] Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200
[ 0.000000] PID hash table entries: 64 (order: -4, 256 bytes)
[ 0.000000] Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.000000] __ex_table already sorted, skipping sort
[ 0.000000] Memory: 12976k/16384k available (2260k kernel code, 3408k reserved, 400k data, 208k init, 0k highmem)
[ 0.000000] NR_IRQS:128
[ 0.000000] Calibrating delay loop... 237.82 BogoMIPS (lpj=475648)
[ 0.040000] pid_max: default: 32768 minimum: 301
[ 0.044000] Mount-cache hash table entries: 512
[ 0.056000] NET: Registered protocol family 16
[ 0.128000] bio: create slab <bio-0> at 0
[ 0.148000] Switching to clocksource MIPS
[ 0.176000] NET: Registered protocol family 2
[ 0.184000] TCP established hash table entries: 512 (order: 0, 4096 bytes)
[ 0.192000] TCP bind hash table entries: 512 (order: -1, 2048 bytes)
[ 0.196000] TCP: Hash tables configured (established 512 bind 512)
[ 0.204000] TCP: reno registered
[ 0.208000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.216000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.224000] NET: Registered protocol family 1
[ 0.236000] audit: initializing netlink socket (disabled)
[ 0.244000] type=2000 audit(0.244:1): initialized
[ 0.252000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.256000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.268000] msgmni has been set to 25
[ 0.272000] io scheduler noop registered
[ 0.276000] io scheduler deadline registered (default)
[ 0.288000] bcm63xx_uart.0: ttyS0 at MMIO 0xfffe0300 (irq = 10) is a bcm63xx_uart
[ 0.296000] console [ttyS0] enabled, bootconsole disabled
[ 0.296000] console [ttyS0] enabled, bootconsole disabled
[ 0.320000] physmap platform flash device: 00400000 at 1fc00000
[ 0.328000] physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x0000c2 Chip ID 0x0022a8
[ 0.340000] Amd/Fujitsu Extended Query Table at 0x0040
[ 0.344000] Amd/Fujitsu Extended Query version 1.1.
[ 0.352000] number of CFI chips: 1
[ 0.352000] bcm63xxpart: CFE boot tag found with version 6 and board type 96338W2
[ 0.360000] bcm63xxpart: Partition 0 is CFE offset 0 and length 10000
[ 0.368000] bcm63xxpart: Partition 1 is kernel offset 10100 and length eff00
[ 0.376000] bcm63xxpart: Partition 2 is rootfs offset 100000 and length 2f0000
[ 0.384000] bcm63xxpart: Partition 3 is nvram offset 3f0000 and length 10000
[ 0.392000] bcm63xxpart: Partition 4 is linux offset 10000 and length 3e0000
[ 0.400000] bcm63xxpart: Spare partition is offset 2c0004 and length 12fffc
[ 0.404000] 5 bcm63xxpart partitions found on MTD device physmap-flash.0
[ 0.412000] Creating 5 MTD partitions on "physmap-flash.0":
[ 0.420000] 0x000000000000-0x000000010000 : "CFE"
[ 0.432000] 0x000000010100-0x000000100000 : "kernel"
[ 0.440000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-oy
[ 0.460000] 0x000000100000-0x0000003f0000 : "rootfs"
[ 0.476000] mtd: partition "rootfs" set to be root filesystem
[ 0.484000] mtd: partition "rootfs_data" created automatically, ofs=2C0000, len=130000
[ 0.492000] 0x0000002c0000-0x0000003f0000 : "rootfs_data"
[ 0.504000] 0x0000003f0000-0x000000400000 : "nvram"
[ 0.520000] 0x000000010000-0x0000003f0000 : "linux"
[ 0.560000] bcm63xx-wdt bcm63xx-wdt: started, timer margin: 30 sec
[ 0.584000] TCP: cubic registered
[ 0.588000] NET: Registered protocol family 17
[ 0.592000] 8021q: 802.1Q VLAN Support v1.8
[ 0.620000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
[ 0.632000] Freeing unused kernel memory: 208k freed
awk: /proc/cpuinfo: No such file or directory
[ 5.340000] roboswitch: Probing device eth0: found a 5325! It's a 5350.
[ 6.456000] There is already a switch registered on the device 'eth0'
- preinit -
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
[ 11.680000] jffs2: notice: (304) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (0 unchecked, 0 orphan) and.
switching to jffs2
- init -
Please press Enter to activate this console. [ 17.400000] Compat-drivers backport release: compat-drivers-2012-12-04
[ 17.408000] Backport based on wireless-testing.git master-2012-12-06
[ 17.412000] compat.git: wireless-testing.git
[ 17.532000] cfg80211: Calling CRDA to update world regulatory domain
[ 17.536000] cfg80211: World regulatory domain updated:
[ 17.544000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 17.552000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 17.560000] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 17.568000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 17.576000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 17.584000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 18.004000] There is already a switch registered on the device 'eth0'
[ 19.100000] Broadcom 43xx driver loaded [ Features: PNL ]
[ 19.164000] Button Hotplug driver version 0.4.1
[ 19.280000] PPP generic driver version 2.4.2
[ 19.884000] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 20.384000] NET: Registered protocol family 24
[ 20.464000] nf_conntrack version 0.5.0 (206 buckets, 824 max)
[ 35.376000] eth0: link forced UP - 100/full - flow control off/off
[ 35.396000] device eth0 entered promiscuous mode
[ 35.408000] br-lan: port 1(eth0) entered forwarding state
[ 35.412000] br-lan: port 1(eth0) entered forwarding state
[ 37.416000] br-lan: port 1(eth0) entered forwarding state
BusyBox v1.19.4 (2013-01-01 18:57:54 CET) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
-----------------------------------------------------
BARRIER BREAKER (Bleeding Edge, r34954)
-----------------------------------------------------
* 1/2 oz Galliano Pour all ingredients into
* 4 oz cold Coffee an irish coffee mug filled
* 1 1/2 oz Dark Rum with crushed ice. Stir.
* 2 tsp. Creme de Cacao
-----------------------------------------------------
root@OpenWrt:/#