I connected successfully through the serial port. This the output I got:
Starting POST - V5.0
SDRAM ... Passed
Loader Checksum ... Passed
20F58F30Loader (V5.00) Self-Extracting ... Done
Decompressing UMON (V1.62) ... Done/Activated
+ has been sent
In udb_init
Out of udb_init+ has been sent
/Activated
+ has been sent
vmode 80002188 = 004018bf
Flash Nex NX25P16 (Capacity=2048K, PageSize=256, TotalPages=8192)
Verifying flash device checksums ...
LOAD: 37120 : Checksum Passed (7616EF04) ...
MANU: 4096 : Checksum Passed (000017F6) ...
APPC: 1024 : No Checksum
PASSED ...
Reading main binary...
Decompressing "TEAppl.gsz" (1451439->5507304) ... Done
Starting ISOS...
Quantum v1.01
Taking ethernet phy out of reset (2)
Memeory Map ---->
Download Image Start ---->0x20001000
Download Image End ---->0x205418e8
Allocata Image Start ---->0x20541900
Allocata Image End ---->0x20feffe0
Allocatable memory starts @ 0x20541910, end @ 0x20feffe0
ZXDSL 831AII version ZXDSL 831AIIV1.0.1i_D18_IN (22 June 2006)
BSP: Vulcan BSP v0.01
CSP: Vulcan CSP v0.01
DSL MODEM
SNMP Research EMANATE/Lite Agent Version 16.1.0.25
Copyright 1989-2004 SNMP Research, Inc.
00 00 17 F6 4D 41 4E 55
SDF verified ok
00 15 EB BF A4 71
00 85 A0 01 01 01
00 85 A0 01 01 02
00 85 A0 01 01 03
00 85 A0 01 01 04
00 85 A0 01 01 05
MAC Checksum: 000008A6
SDF Checksum: 000017F6
Starting the command Register again in BUN
Connected Phy is a Single Ethernet Port PHY
im:Permission denied:Illegal attempt to write to DSLHome data model
im:No such device:No Ping Session exists
im:Invalid argument:Failed to set Standard to Unknown (542)
Ethernet: State Changed to Half Duplex
im: ext-dmz: Policy interface types must be different.
im: Reading owned node but no read lock acquired
/task/webserver: SSL/RSA certificate setup: SSL_CTX_use_certificate_file() failed
/task/webserver: SSL Server init failed
CLI started
***********************
Welcome to ZXDSL 831AII
***********************
ZTE Corporation, Software Release ZXDSL 831AIIV1.0.1i_D18_IN
Login:
Information about this model is scarce. Please tell me what can we infer from this serial output at the startup. What should I enter in the login field?
Akhil